Colloidal Silver - What
is this?
As you know, we bring you information about natural
methods usually not employed by conventional health care practices. The
use of these ideas have proven to be routinely effective in the hands of
independent minded individuals wanting to take responsibility for their
own health and the well being of others.
Bio-plasmics.org
is now offering one of best colloidal silver generators available. For
detailed specifications and how to purchase one go
here.
COLLOIDAL SILVER
Colloidal Silver is a near perfect antibiotic. Just about every known
pathogenic germ, bacteria, virus or fungus, will die within six minutes of
contact with colloidal silver. In addition, there are no known bad side
effects from using colloidal silver. Silver can be used topically or
internally.
For burns or sores that may be infected, use a bandage to keep a cotton ball
soaked in colloidal silver on the wound. That approach will also help with
warts.
Women suffering with a vaginal yeast infection can use 1 Tablespoon of
colloidal silver mixed in with 8 oz. of water as a douche solution for
almost immediate results.
For infectious diseases, colloidal silver can be taken internally either
straight or mixed with liquid or other preference. If you are dealing with
an existing infectious condition, you may want to take 1 tablespoon of
colloidal silver three times a day. AS the condition improves you can reduce
dosage to two tablespoons a day and then reduce to once a day.
For general protection form colds, flu and other infectious diseases, a
daily dose of one tablespoon is recommended. Only increase dosage if a
condition develops in spite of the normal daily dosage. Call if you have any
question or want to discuss treatment of some particular situation.
How Colloidal Silver is Made
The Physics of it....
Colloidal silver is made in half-gallon batches using a 10,000-volt A/C
transformer. A bar of 99.99% pure silver is suspended from one electrode
into steam distilled water. A small piece of 99.99% pure silver wire is
suspended form the other electrode just above the water. The process is very
similar to that used to electroplate a precious metal onto an object except
that the absence of a receiving object at another electrode causes the
silver to remain in a colloidal suspension in the water.
On one cycle, high voltage electricity flows through the bar and tiny
particles of pure silver are separated from the bar and attempt to make
their way to the other electrode. Since the wire is suspended above the
water the silver cannot make its' way to the electrode and remains in a
colloidal suspension in the water. On the other cycle, electricity flows
through the wire suspended above the water and a blue arc of electricity is
created between the wire and the water. This is a null cycle and no silver
is added to the water. The extreme heat of the arc slowly vaporizes the
silver from the tip of the wire and eventually the wire needs to be
replaced.
Editor's Note:
The above only describes one method. See the
links section below for more practical methods for making your own.
[page 1][page 2][page
3][page 4]
next>>
